Select Data list. Scroll to the bottom and check the status of the immobilizer. It should read BAN with a Red dot. If it does, exit the data list and press IMMOBI button. (see below) If it reads RUN then the immobilizer has not been enabled in the K-Manager software. Quit then relaunch K-Manager. Open your calibration. Question type: General. My Touareg car key fell on the floor i tried to start my car with it and immobilizer. activated was displayed on my dashboard. i tried my spare key which i didn't. use for almost 2 year and the car didn't start also. i tired removing the earth. cable for like 10 minutes and put it back again and still immobilizer activated. First, locate the key slot and insert your key. Turn the key to the “on” position and wait 10 minutes for the immobiliser to reset. If this doesn’t work, disconnect the battery for 30 minutes and then reconnect it. Keep in mind that common mistakes include not waiting long enough and not following the correct steps. In this video we are going to see the process that is carried out to cancel / deactivate the electronic immobilizer system of a RENAULT vehicle, in this case Step 1: Check for the anti-theft light. It’s located on your dash and will have a blue or red light. Step 2: Turn the ignition to the "on" position. Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. 20 Answers. SOURCE: How do I know when oil pump sensor is faulty on endura de (ford bantam 1.8diesel)and where is situated on the block,please help agently. I'm not too experienced with these kind of vehicles. However I believe this image should help you locate your oil pressure sender. knowing the vehicles year would help. The second option for me it was to save the eeprom bin from my ECU, disable the immobilizer (with tools), and rewirte the new bin in the ECU, but I can't save the eeprom. I see I can also disable the immoblizer direct from VAG K+CAN commander but I can't access to this option, like I can't save my eeprom. And I would like to know why To do this, turn on the ignition, use your centralized button to enter the digits, several quick presses (example: 2 for digit 2) then a stop of one and a half seconds to confirm the digit and resume, duplicate the process until you have entered the whole code. This should enable you to start your Volkswagen Transporter without having to remove PUwp.